Hello Kinini, this is the last section of my paper which covers two headings. Please read the instructions
carefully as follows: Read the Unit VIII Study Guide (see attached), then consider the control technology options available for our scenario. Make your first Unit VIII section level 1 heading titled “Pollution Control Technologies.” Select appropriate control technologies to be used in the final exhaust air from the spray booth for the following pollutants: (a) gases and vapors, (b) aerosol particles, and (c) noise levels of 90 dBA at 1,000 Hz. Be sure to defend your suggested engineering controls with literature. Next, make your second Unit VIII section level 1 heading titled “Process Flow Diagram.” Map out the entire process by developing a drawing of the process. You might consider reviewing the drawings located within Appendix G and Appendix J in the TCEQ (2011) document and Figure 10.12 on page 381 of your textbook as good examples of clear and understandable process drawings to help you construct your own Process Flow Diagram.
Note: Since this section has two headings and a process flow diagram, I am adjusting the rate to $30, and will provide an additional $30 tip for good original work. I will definitely work with you on future classes. Thanks (As always please cite and reference as required using APA formatting).
Running head: POLLUTION CONTROL TECHNOLOGIES Pollution Control Technologies and Process Flow Diagram Student’s name University Name 1 POLLUTION CONTROL TECHNOLOGIES 2 Pollution Control…